This is a set of alignment blocks to setup your D Loop location on your paracord and for setting up other standard (Non Whisker Biscuit) arrow rests that you may have adapted for the X Bow v2 Ultimate Edition by: https://www.thingiverse.com/mussy/designs

Works by centering your arrow shaft in the bow chassis.

The cradle is for 8mm shafts. So if your arrows are less, apply layers of blue masking tape to compensate. Just enough to raise the arrow half the difference in size.

If you're having trouble fitting the molded reliefs onto the chassis, reprint and add 1% to XY&Z.

No

No

.2

10%