I decided to make one because others doesn't suit my liking. I also wanted to house 'everything' in this single case without leaving out something else, while I don't have a soldering iron holder, I decided to incorporate into this as well.

• Store 2 tips at once
• Meant to house everything a ts80 need
• Stand/holder to put the ts80 safely during operation

Included 2 stands file, if the stand slab is loose from the divider, print the tighter version, it is meant to be snug fit with the divider. Spool are meant to be glued together then wind solder lead. Use any 1.75mm filament to hold between top and bottom case together. I suggest do a test print of top case first and try the clearance. Sand a little if it is too tight, put something if it is too loose.

Like this design? Consider tipping me I highly appreciate the support. =D
https://youtu.be/dwCmYtk-o6U

Prusa

i3 MK3 MMU 2

No

No

0.2

10-20

Print the divider and stand part in 100% flow to let these parts able to latch onto themselves

19th June 2020

• It seems that there is a newer TS80P came out, it should able to fit with the case based on this spec http://www.miniware.com.cn/wp-content/uploads/2020/05/%E6%9C%AA%E6%A0%87%E9%A2%98-1-1.jpg
  Referring to the second picture above, TS80P should be shifted to left side to accommodate the draft angle handle design.

26th April 2019

• Bigger case added has 190 x 85 x 40mm storage dimension for bottom case under request by nickholus