J1Sys P2 In case base
Emma Wallace
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2019-05-25 22:29:21
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
Summary
A simple base to allow mounting of the J1Sys P2 Pixel Controller in the aluminium case, onto a board or backing plate. This uses tow of the case end bolts to mount to the case. You may need to elongate the holes slightly to fit the P2's bolts in, depending on your printers accuracy.
This was printed in ABS, but PLA is fine
Print Settings
Printer Brand:
FlashForge
Printer:
Dreamer
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC BY