Coffee Spoon Rest
coastalbeacon3
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
1
0
Publicado:2026-01-03 20:30:57
0
0
010Descripción
Fuente del modelo
Comentarios(0)
Summary
A place to put the spoon after the coffee has been stirred.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.4 nozzle
Infill:
20%
Post-Printing
My wife likes cream with her coffee, I usually drink it black, but sometimes I do add creamer. We always used a paper towel to put the spoon on so we could reuse it throughout the day. I designed this small spoon rest to take place of the paper towels.
I never had a problem with my prints not sticking, so I only use a skirt to prime and clean the nozzle before the first layer. I used tree support touching the build plate just because of the lettering, but my guess is, that it would print fine without them. The bridge is not that much and I would think most any 3D printer could handle it. Took just little over an hour to print. I air brush painted mine so it would look nicer sitting next to the coffee maker. I generally print most things at 20 to 40% depending the weight I am going to put on it and if it is going to hang on a pegboard or not. Most of my pegboard designs I print at 40% just so the peg has a little more strength.
Fuente del modelo
Enlace original: Ver detalles
CC BY-SA