Inner part of arcade button with START and SELECT mark to be used on standard arcade buttons assemblies with 28mm diameter.

The parts are 45mm long and fit the standard arcade button assemby of 63mm.

I uploaded the "ungrouped" version of the components so you can modify the lenght to fit smaller lenght arcade buttons assemblies.

This is part of a project to create arcade buttons with the typical Retropie buttons nomenclature.

Creality

Ender 3 Pro

Doesn't Matter

Yes

200

20

The best way to print in my opinion is laying the components in a diagonal way.

I used BRIM for adhesion.

I used minimum support (the most important thing is that the slicing software doesn't add supports to the START and SELECT words. This is to make sure the top of the button results clean).

I terms of infill % i used 20% but you can modify it as you prefer.