Hopper Bird Feeder
henry4602
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2021-07-28 16:50:04
0
0
000Descripción
Fuente del modelo
Comentarios(0)
Summary
This is a bird feeder I designed after printing and using a soda bottle design that is very similar but only facilitates very small seed. Near as I can tell as long as you're not feeding your birds marbles this one should work for you. You'll need to glue the 1/4 inch roof plug(if you do not intend to hang the feeder) and the hopper onto the base into place but outside of that everything else is dry fit. Any tips are greatly appreciated and I hope you enjoy
Print Settings
Printer:
Pursa Mini
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
10
Notes:
Clear was used on the hopper liner and printed at 0.35mm
Fuente del modelo
Enlace original: Ver detalles
CC BY