Twin DCS garage remote control case replacement
Bruno Yount
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-05-02 14:38:11
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
My Twin DCS garage remote control broke, and after searching online, I couldn’t find any existing STL model to replace the broken part.
I decided to design my own model from scratch using FreeCAD.
Design
The model was fully created in FreeCAD and is intended to be simple to print and easy to reproduce on most FDM printers.
Print Settings
Material: PLA
Layer height: 0.16 mm
Supports: Not required
Notes
The part printed successfully with these settings and fits as expected.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY