Wall mount for ZIMA BOARD2 and two 2.5" HDD drives. Only screws are to fix holder on the wall, all other does not need any screw, just put ZimaBoard in a slot, from a top HDD drives also. All cables and connectors are free to be plugged - are not covered. It side has hole on a side to see if ZimaBoard2 has power. All done in OnShape by PTC.

20.3.2026 Update

I added desk stand, no screw needed, just put enclosure in the stand and that is it, no screw needed.

Print settings : AzureFilm PETG, 0,3 mm layer height

Nozzle diameter : 0,6mm Printed standing up 4 Walls No top and bottom layers honeycomb infill 25%

Category: 3D Printing