The washers are 1mm in hight making it possible to install T-mount drone props with the standard size M2 x 8 mm screws. Set of 4 washers.

Instead of of the hightly irregular size of M2 x 7mm normally used with these props.

Printing:

DO NOT USE TPU FOR THESE!!! Compression of washers printed in TPU can cause the screws to go in to deep and damage your motors.

So use a hard material like PLA of PETG for this

Have a good flight :-)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

100

Infill:

Filament: Generic PLA Post-Printing =============

Cut the washers free from the attached cross (needed for bed adhesion)

Category: R/C Vehicles