Wall mount for Tab A8 tablet. 

Instructions for assembling from original author:

Four piece build allows tablet to be taken off wall without completely removing the case.  One base piece permanently attaches to wall via screw(s), while the second base piece slides into mounted base piece.  The front two pieces hold tablet in place by “snapping” into base pieces via pegs/holes.  While it's recommended that front pieces be glued to the base pieces, the pegs might hold just fine.  Again, the design was such that if tops are glued to base that the case can be slid apart to remove the tablet.  When facing the case, holes in the left side accommodate speakers, holes on the top grant access to power button, and holes on the right are for speaker and access to charging cable.  A 90 degree charging cable is recommended.  

Printed in PETG, but it can work with PLA as well.