I built this stadium originally out of Lego and expanded it each year, but it was getting expensive, so instead I designed and printed this expandable set of stadium components

Print the stadium in either 1,2 or 4 figures wide and then print the appropriate base for each figure (usually the Plate 2 Peg) and a plate mate, glue the pate mate to the Plate and once dry insert into the stadium.

You can then reconfigure or remove as required

Print without supports, print the stadium bases on their side with the walled side down, print the plates with pegs/studs up

Anet A8

No

No

0.2

10%

Print without supports, print the stadium bases on their side with the walled side down, print the plates with pegs/studs up