Lego Kylo Ren Command Shuttle Wall Mount
Galeleth
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
1
0
Publicado:2026-05-29 13:27:48
0
0
010Descripción
Fuente del modelo
Comentarios(0)
Low profile wall mount for Kylo Ren's Command Shuttle (75104).
Four parts:
- Bracket screwed to the wall
- Tongue that attaches to the Lego model
- Insert that locks the tongue to the model (or you could use a 2x2 and a 4x2 Lego instead, but its difficult to get the 2x2 piece out if you want to remove the model from the bracket after putting it up...)
- Lockpiece that secures the tongue to the bracket
Not sure whether this would work for 75256 Kylo Ren's Shuttle Lego model - it looks like the back where the tongue attaches is similar, but dont have the 75256 model to check.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.15
Infill:
70%
Filament: EDA PLA+ Silver
Notes:
The infill for the tongue needs to be high (70%) as it takes all the load from the model, but can be reduced for the other components. I upped the perimeters to 3 for the tongue as well.
Printed it in silver to help it disappear more into the background. Supports are needed for the bracket (for the lockpiece hole), and for the tongue (for the gap which slots into the model and the Lego holes on the bottom), and the insert (Lego nobbly bits).
Fuente del modelo
Enlace original: Ver detalles
CC-BY