Holder for a car trash (from Baseus), that can be mounted e.g. on the side storage of the car.

The first design (large) was meant to be printed in PLA or TPU, but it appeared to be too long, and the trash was crashing while closing the doors.

Other issue of printing in PLA/PETG is that the holder was causing some scratches on the car storage surface.

Finally (final version) was designed to be printed in TPU (no need of supports !) and it doesn't cause any problem in opening and closing the car doors.

I've printed it in blue TPU.

All speeds - 25 mm/s

Layer height - 0.2 mm

Infill - 45 %

Printing temp - 220, plate- 50/60

Flow - 110%

Print Settings

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Filament: n/a TPU blue

Category: Organization