uhm… that VR headset is a better microphone than my old T-bone so uh… here's a mic stand adapter for it

easy print, here's my settings:

• 0.4mm nozzle
• 0.5mm line width
• 0.25mm layer height
• 2 perimeters (1mm wall thickness)
• 2 top & bottom layers
• 50% cubic infill
• no supports

only thing to watch out for is getting the magnets in in the right orientation but it's not hard to figure out

I might make another variant that can accommodate the face gasket & strap, for quickly switching between VR & mic use as this would be the more common use case I think