Quick and easy tool that will making tapping holes in your printed parts much easier! Holds a variety of small thread taps. These things are readily available at most hardware stores, but why spend the gas and few dollars when you can print one out in 20 minutes? Plus you'd be missing out on my Tri-Lobe™ Comfort handle (patent pending).

Sadly, you have to tap three holes for it to work...use a pair of pliers I guess. it will be the last time you have to, I promise! Sized for 6-32 bolts, but M5 should work too. Two should be tightened until the bottoms are flush with the inside of the tool, these provide a wedge for locking the tap in place with the third. Why is there only one in the picture though? I cheated, used set screws I had lying around for the other two.

dense is better