Water wheel
paprikapile2
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
1
0
Publicado:2025-04-23 19:50:17
6
0
010Descripción
Fuente del modelo
Comentarios(0)
Este contenido se ha traducido automáticamente. Mostrar original
I made a water wheel for my parents' pond.
It's very easy to assemble, and all the components can be printed.
- Take it off.The main bodyAnd it will beArm 1"And"Arm 2"Stick it on it."
- I'm ready.Round 1"Or"Round 2"Rod 1"Insert it into the wheel and drip the glue in"Rod 2into the hexagonal hole, and then insert it into the wheelRod 1"Connect."
- Finally, just insert the complete wheel between "Arm 1" and "Arm 2", and it's done!
The main body is ready to be used with a 40mm pipe.
I recommend using PETG material.
You can check from the photos how to print each component!
Fuente del modelo
Enlace original: Ver detalles
CC BY-SA