Adjustable Picture Hanger
Pimolix5
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-04-01 13:41:40
0
0
000Descripción
Fuente del modelo
Comentarios(0)
This is an adjustable picture hanger, to be combined with:
- a nail whose shank can fit through the nail holder part and whose head can fit through the screw hole (not the nut)
- a #8 square nut
- a #8 machine screw
- a 3M Command strip, large size
You'll need two of these hangers attached to a wall, with the nails pointing up, to hang a picture. The screws let you adjust how far the nails stick out and you can adjust them until the picture frame is perfectly level.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.1mm layer height
Notes:
I printed this on a Formlabs Form 1 with Clear resin v2 at the 0.1mm layer height setting. I printed it directly on the plaform, flat side down, without any supports.
This was modeled in Autodesk Fusion 360. You can get the original model here: http://a360.co/1Jxg4MO.
Category: DecorFuente del modelo
Enlace original: Ver detalles
CC-BY