instructions for building a hydroponic tower for 9 plants

the tools needed
40w soldering iron
3d pen
plastic pipe for water 20 mm
3d printer
drill and 4 or 5 mm drill
18 liter bucket
4 buckets of wipes
a pump for a 10w aquarium that raises the water to a height of 1.20 meter.
a4 adhesive paper for the printer
plastic icons
2 tubes of plastic for sealing
Assembly instructions
take the 3 buckets and mark the location of the holes.
Then carefully cut with a surgery knife. Then paste the triangles with a 3d pen
once the triangles are connected use a soldering iron to strengthen .after then stick the sample to the lid of the large bucket and to the bottom of the small bucket to be centered. Grab with 3 zip tie thet will not move and drill the holes, then do the same with the small buckets .bottom of bucket with lid of bucket underneath .then connect the air pump to a 20 mm plastic pipe .then drill all the buckets in the center .or cut
with a cutting knife that the pipe will pass through
all the buckets.in the top bucket cut the tube in its top third and connect the .sprinkler
then fill water in the large 18 liter bucket and connect all the buckets together. And check that system is working regularly.then seal the lids of the buckets with sealant to prevent leakage. Then let the system work 24 hours.replace the water and the system ready for operation

Assembly instructions
take the 3 buckets and mark the location of the holes.
Then carefully cut with a surgery knife. Then paste the triangles with a 3d pen
once the triangles are connected use a soldering iron to strengthen .after then stick the sample to the lid of the large bucket and to the bottom of the small bucket to be centered. Grab with 3 zip tie thet will not move and drill the holes, then do the same with the small buckets.bottom of bucket with lid of bucket underneath.then connect the air pump to a 20 mm plastic pipe.then drill all the buckets in the center.or cut
with a cutting knife that the pipe will pass through
all the buckets.in the top bucket cut the tube in its top third and connect the .sprinkler
then fill water in the large 18 liter bucket and connect all the buckets together. And check that system is working regularly.then seal the lids of the buckets with sealant to prevent leakage. Then let the system work 24 hours.replace the water and the system ready for operation

the tools needed
40w soldering iron
3d pen
plastic pipe for water 20 mm
3d printer
drill and 4 or 5 mm drill
18 liter bucket
4 buckets of wipes
a pump for a 10w aquarium that raises the water to a height of 1.20 meter.
a4 adhesive paper for the printer
plastic icons
2 tubes of plastic for sealing