A pen holder for screwing to a wall

read the print instructions as the STL on its own is useless without a few tweaks to the profiles

Look at the other pen holder that i have uploaded

https://www.prusaprinters.org/prints/1363-honeycomb-pen-holder

Print instructions

The STL is just a solid with two screw holes in it

To turn it into a penholder you need to turn off the top layers and have a hex infill set to 6%

If you do this then it works but the screw holes end up looking a wee bit off

So if you use the 3mf file you will see i have added two off modifiers which turn on the top layers and increase the infill just at the ends

This gives you a better finish on the screw holes