Sturdy box with very smooth lid. This box prints with no support needed in the box lid tracks. The angles there are greater than 45 degrees.

Dimensions: 6.5 x 3.5 x 1.5 inch, scale to your needs.

See instructions for more details.

Video demo attached in files.

Printed box picture shows old version of lid. New lid has more rounded corners and fits perfect.

This box is a simple and very sturdy box. Its lid slides smoothly. In the video you will see it was a tiny bit difficult to insert the lid in the track. This was because of sharp lid corners, which have now been fixed.

If you are going to be putting this box vertically I recommend you drill 3mm holes for neodymium magnets in the lid and base (see the end of the video clip). I used 3mm x 1mm round neodymium magnets from amazon. Cost was $5 for 50. I used a bigger drill bit so I had to superglue the magnets in. I was very sloppy as you can see.

I also recommend you do a acetone bath for the base at least. My acetone had White ABS in solution as a result my base was discolored.