My wife tells me I have too many bikes, but we all know we have one less bike than we need. So in order to manage my inadequate bike collection, I needed to start hanging some of them up to make room to walk in the garage.

Well of course I'm going to 3D print them.

This hook should hold almost any bike. It will fit a 29" wheel with a 2.35" Hans Dampf and anything smaller. My mountain bike is ~13kg and it has no problem holding it. I've designed the hook to mount to a standard 16x100 fence paling which allows for mounting like in the photo and some adjustability in the distance between hooks. The photo shows the last iteration in front and the previous two iterations behind.

Here is the Fusion360 link if anyone wants to remix: http://a360.co/2pZXGxk

Prusa

Prusa Mk2

No

No

0.35mm

10% (rectilinear @ 45°)

Print with at least 5 perimeter layers with an extrusion width of 0.5mm, and I use 5 top and bottom layers, though this is almost irrelevant as using 5 perimeters makes it virtually solid.

Print is ~9 hours and has a mass of less than 200g.