Filament Funnel
BlitheArch
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
1
0
Publicado:2026-02-27 12:16:38
2
0
010Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
Print Environment:
Printed and Tested on a K1C Printer with Overture PLA Filament(Gray Blue) with Default Bed Temp(220) and Hot End(55) with no support needed, Sliced on Orca Slicer(2.3.0)
Assembly:
Fits onto "Creality White PTFE Bowden Tubing" or any Tubing 4mm in diameter, No Additional Hardware
Usage:
Purpose is to make swapping filaments more efficient, its holds onto the PTFE Tubing by friction. it has a recessed top to help it slide onto the PTFE Tubing
Notes
May have a small amount of friction for the first few times when putting filament through this was intentional to prevent the filament from hitting/catching anything before going into the Bowden Tubing and it goes away after a few uses
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC BY