I re-purposed an old laptop lap-board made of wire shelving racks to mount my Thrustmaster T16000m HOTAS setup and Logitech K400 Keyboard. The plates for the Throttle & Joystick have grooves in them to lock into the wire rack and provide lateral support. M6x16mm screws (2) are used to secure the plates to the HOTAS components.

Print instructions

Category: Computer Summary

Print Settings

Printer Brand: Prusa
Printer: i3 MK2S
Rafts: Recommended
Supports: No
Resolution: 0.2mm
Infill: 30%

Notes:

I did not use rafts and had some pulling along one of the edges. Would use rafts if I had to print again.