The funny giraffe HueForge

If there's anything you're not clear about, just write to me here and I'll answer it for you.

On my A1, it took me about 4 hours and 19 minutes to print it.

You won't regret sacrificing your time.

Please make sure the slicer is set up correctly.

HueForge must comply with the following settings.

The thickness of the first layer is 0.16 mm

All the others are 0.08 mm

Only the exterior wall 1

Fillon, 100%

I set the speed to 60/300 for outdoor use and rest

Starting with black

Switch to blue-grey on layer #6

Switch to gray on the #12 layer

On the #18 layer