Project: Calavera Clown.hfp
Print with a layer height of 0.08 mm and a base layer of 0.16 mm, with a fill rate of 100%

The model's dimensions are 182.81x240mm.
You can use a higher layer height below a minimum depth of 0.48mm.
The maximum depth is 2.2mm, and the actual depth is 2.2mm.

Consumables used:
PLA PolyLite Black, transmission distance: 0.3
PLA BambuLab Basic Blue-Grey. Transmission distance: 3
PLA PolyLite Grey, Transmission Distance: 1
PLA PolyLite White, Transmission Distance: 5
This printing process uses four unique consumables

Switching instructions:
Starting with black
Switch to blue-grey on the 8th layer (0.72mm)
Switch to gray on the 15th layer (1.28mm)
Switch to white on the 21st layer (1.76mm) and keep doing so until the end.