Project: Joker.hfp
Print with a base layer height of 0.2mm and a layer height of 0.12mm, and use 100% infill.

The model size is 150x150mm.
You can print at a higher floor height of less than 0.8 mm in minimum depth
The maximum depth is 3mm, and the actual depth is 3.1mm.

Consumables used:
PLA PolyLite Black, transmission distance: 0.3
PLA PolyTerra Lavender Purple. Transmission distance: 0.5
PLA BambuLab Basic Green. Transmission distance: 2
PLA BambuLab basic model in jade white. Transmission distance: 5
This printing process uses four unique consumables

Exchange instructions:
Starting with black
Switch to lavender purple on the 10th layer
Switch to BambuLab Green on the 14th layer
On the 18th layer