A tool used to make springs from consumables.

How to use it

- Take a piece of unused consumable material

- Use a hair dryer, lighter, or other heat source to heat the consumables until they are soft enough to be wrapped around the grooves of the printed object.

- Wait for it to cool down

- It might be a bit difficult to remove the spring. Personally, I find it easiest to unscrew it from the groove like twisting a screw

Size

- 10 centimeters in height

- Diameter: 1.5 cm

- 1.75 mm wire diameter / depends on your consumables

- 17 laps