I had an issue: if I crashed, the battery would be cut out on the carbon plate. FPV pilots usually mount a GoPro in this location. However, I mounted my VIFLY Finder 2. When I crashed the VIFLY Finder 2, it would get pushed off.

To solve these issues, I created this simple model.

You will need longer bolts to use this model.

Also attached is the FreeCAD 3D model.

It works optionally with the VIFLY Finder 2 Holder. There is a little cutout for the Finder 2 wires. See the attached picture:
https://www.thingiverse.com/thing:5768782

Bambulabs

Bambu P1S

Yes

0.2

35%

Any non-flexable filament can be used. Since you want this part to be strong, I recommend using a wall thickness of 7 layer lines and 35% infill.