One of the shafts of the AR.Drone Parrot broke, and I needed to find a way to repair it. So I decided to print a repair kit for it. It is plastic holder that keeps two broken parts together and doesn't let them go apart. Since it is secured with screws and nuts melted into plastic, the whole part is very solid and reliable. After printing you just only need to melt the nuts in the plastic with a soldering iron, and assemble it.

NOTE: This part is suitable for the particular shaft shown on the picture. It might not fit if another shaft is broken. Unfortunately I did not have opportunity to check that case.

Flying Bear

Flying Bear Ghost 5

0.6

50