A simple storage container compatible with Multiboard. This is an easy-to-print model that takes about 1.5 hours to print on the Kobra S1. The model also uses 35 grams of filament, including support material.

As shown in the figure, this is the same size as the battery of the BoboVR Quest 3.

This will require the use ofThe screws for 3D printing compatible with multiple boards are linked below. This model requires two screws.

https://Thangs.com/designer/multi_board/3d_model/9%20mm%20small%20thread%2C%20small/20_thread%20head%2C%20Bolt-974141

Printers settings:

Floor height of 0.2mm

15% filler

Automatic generation of supporting materials