Version 2 is out with a ton of improvements!!

Check it out here - https://makerworld.com/en/models/1536377-dummy-13-locking-stand-v2#profileId-1611814

Added locking points so you can lock it into positions in 45 degree increments.

It improves the durability of the stand to hold positions; it seems to hold up much better than the original.

It should be printed at a .15mm layer height.

Printing this in PETG or better material works good just not PLA.

This works with all the original adapters for the whole 13 family.

You can find these in the print profile labeled accordingly.

Note: You don't need all of the extra arms, just one; I got carried away and made a few different types.