This is a communion cup holder that clips to a chair. Our church did not have enough chairs with communion cup holders, so I made a little thingy that will clip to the bars underneath each chair. The bars were not at a reliable separation distance, so the thingy has a deep slot on one side. In order to make the deep slot look better, I shaped it like the tail of a fish.

Creality

Ender-3 V2 Neo

No

No

0.16

30%

In order to print without a raft, set the nozzle to be right above the printing surface so that the first layer is forced into the surface. Having it stick well will allow the printing of multiple copies on one surface. If each thingy does not stick well, the nozzle will knock over some and make a big mess.

Printing with supports is not recommended when printing the thingy sideways as shown in the images. If supports are added, then the nozzle could knock them loose and make a big mess. (Supports must be used if the object is printed flat but be aware that the supports are very difficult to remove from the slots.)