A slotted thingy to help water drain from soap in a soap dish.

Instructions

[why is it only after publishing this that I notice how much our bathroom corners need cleaning?]

I was asked to make a small thing to put under our soap so that water didn't pool under the soap and make the soap dish ineffective -- this is what I came up with.

My first print attempt (shown) only printed about half way before repetier crashed on me, but it should be functional enough.

Parametric SCAD file is provided which allows for adjustment of width, length, height, hole width and support width. The upper gap is set at 2mm wider than the lower [specified] gap, with the intention that water is less likely to stay up the top.

To clean the soap drainer booster, place in front of a windproof barbecue lighter and heat until it becomes a big blob.