The original design was too small and the DAS did not clip onto the side so I shrunk the ball joint a little and also made a blocker that can be clipped on to prevent rotation in case it gets uncomfortable like it did for me, as there is a lot more forehead pressure, this just makes it function like a normal adapter.

INSTRUCTIONS: Use a hairdryer or heater gun to get the adapter hot and flexible then mould it to the side of the strap adapter (May take a few tries), also try and bend in the sides to create a tighter fit.

Rotation Blocker: Slide the hole over the adapter and quest 2 strap part then have the flat bottom surface over the top of the adapter and leave the gap part at the bottom of the DAS.

Printing: I printed the adapter in PLA and my printer managed to bridge the gap perfectly fine but you may need supports, No additional processes needed for the rotation blocker.

Tronxy

Tronxy XY-2 Pro/Pro 2E/XY3 SE

Doesn't Matter

Doesn't Matter

0.2