I thought maybe the inner wheels of Wingman94's excellent Raspberry Pi ZeroBot Pro design needed my signature Ying Yang bling ;)

You can find Wingman94's design here: https://www.thingiverse.com/thing:2800717

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

.2 layer

Infill:

Notes:

The original design printed best with the outside surface down. You could probably print this remix either as it is, or upside down. You'll have to use support either way, but I think you'll get the best results printing it as it sits in the design with the outside surface pointing up. The supports are a pain to clear out of the center hole, but they'll come out with patience.rnI used 20% infill for most of the print, and then 50% for the last 3 or 4 mm's of the print - makes the top (outside) surface come out smoother since there are very few layers once the design starts. rnrnFYI: I used Prusa's ColorPrint for the color change for the Ying Yang on top - https://www.prusaprinters.org/color-print/

Category: Robotics