Remixed holder for Fluke 87, including source files from Rhino. This also includes sockets for small rubber feet (13 mm circular).

I removed the probe holders; stiffened the rear plate; rounded edges and slightly tightened the DMM support. I also added 4 sockets for rubber feet.

Prusa

Prusa XL

No

No

0.2 mm

15 %

Generally supports are not preferred for the sockets for the rubber feet as they are too difficult to remove completely and are not really necessary for such small bridges.

Be sure to orient the print so that the rear support plate is on the print plate. This is a rotation by 12.5°.

I use 13 mm (½ ") circular rubber feet. The sockets are inverted cones which lock the feet in place very solidly. They protrude about 1 mm from the lower surface.