Although I was lucky when using Sporegod's Spiral Goddess model, I encountered many problems when trying some more special consumables
The original model had a concave bottom, which resulted in a lack of contact between some overhanging areas and the print bed. At the print size I used, it was quite difficult to successfully print these areas. Additionally, the adhesion of the marble-patterned PLA was extremely poor. To ensure print stability, I had to switch to raft support for printing—however, this inevitably left noticeable texture flaws on the surface of the model's bottom.
The new version adopts a completely flat bottom design, which can maximally enhance the adhesion to the print bed. At the same time, the number of triangular faces in the model has been reduced, making the slicing process more convenient and efficient.