A wall fixture to hold a pair of bulbs, to be used with a pair of cheap threaded pendant E14 pendant holders.

The threading is designed to mate with cheap threaded pendant E14 light fixtures that can be purchased from Amazon and other retailers; unscrew the wires connecting it to the circular rose and screw the threaded portion into the fitting. For reference, the threading required is a pitch of 2mm.

Can be printed without supports. I printed it at 0.2mm resolution with 12% infill.

Bear in mind that PLA will droop if the temperature gets too high, so I'd recommend only using it with LED bulbs of a reasonable wattage, particularly if you are putting any kind of enclosure on the fitting that will reduce heat dissipation. Consider using a filament that remains stable at higher temperatures if your use-case will involve said temperatures.