Summary

This battery pack is used in for Avatar Google X FPV Goggles using the DIY battery holder: https://www.thingiverse.com/thing:7108440.
It can be used for any other purpose also.

Print with ASA / ABS / PETG for best results.
Features a plug holder to organize the dangling balance connector and main connector. The plug holder is glued to the assemble as shown in the picture.
Note: This plug holder is designed for XT 30 connector.

Assemble the battery and solder the wires to the cells. Use a drill to enlarge the holes if needed.
to secure the assembly use a needle and thread and tie it multiple times through the holes. Put Super glue on the thread and the joints to permanently secure the assembly.

Optional: Stick foam tape on the caps