My daughter will be dressing up as Kotoha for Gencon this year in Indy. She came by and was talking about the necklace that Kotoha had and how she was going to get one. Seeing as i now have 2 3d printers i thought here is a perfect time to put them to use. once again showing everyone just how much everyone needs one of these around :)

I was going to try and print these in 2 colors but am still working out how to get them prints to line up correct. So i just printed all the parts and used a small hammer to put the middles into the disks and the outer ring of the middle disk just pushed down on it. we did not have to glue it but someone else might.

Also made a hair pin that Kotoha wears. it wasnt perfect but i have a few months to work on it might make it better later.

Geeetech I3

No

No