Vexclaw Extender
MichelleGarcia
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2019-06-07 05:05:15
0
0
000Descripción
Fuente del modelo
Comentarios(0)
Summary
This is an extension for the standard vexclaw, I just attached it to the vexclaw with 3 zipties and mirrored the model in Cura for the right side of the claw.
The holes for the zipties are a bit small and you might want to check if your zipties are too wide. Also the tip of the claw is a bit thin.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.3mm
Infill:
15%+
Notes:
I could upload revised version for larger zipties and stronger structure
Fuente del modelo
Enlace original: Ver detalles
CC BY