This is a more stable stepper motor mount for the Hypercube Evolution.

I had the problem that my mounted motors (using the original mount) produced some nasty vibrations, that you was able to see on the outer shells.

This mount uses a square nut to clamp the Y-axis, because I "don't like" brass inserts. ;) !

I printed it with PETG between 15mm/s and 60mm/s with 30% Gyroid infill and a layer height of 0,2mm.

Anet AM8

No

No

0,2mm

30% Gyroid

Rotate the mount by 180°! The hole for the motor must be at the bottom.