Adimlab BMG Extruder Bracket
Trevor Allen
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-03-17 03:05:35
0
0
000Descripción
Fuente del modelo
Comentarios(0)
This is a bracket to mount a dual drive BMG extruder on the existing carriage for the large adimlab printer
Print Settings
Printer:
Adimlab
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
30
Filament:
Solutech PLABlack
Notes:
This bracket allows you to use the carriage and existing stepper without issue. You will need to either get 3 - M3x40's to attach through this bracket or drill the holes for the factory provided screw and additional 3mm deep as the screws that come with the BMG are 37mm and this bracket is 2.4mm thick, and then the metal bracket add 2mm more.
This design also requires 4 - M3x5mm, or up to 8mm, and uses the holes that are for the LED strip mount on the bottom of the metal carriage. The LED strip will need removed for this. The holes in this bracket are designed to just screw the M3's right into the material.Please Note: Due to the thickness of the BMG, you will need to adjust offsets in your firmware, also the fins hit the carriage slightly, so when you install this, the carriage metal will slightly insert between the second and third fins from the top.
Fuente del modelo
Enlace original: Ver detalles
CC-BY