Case for Bus Servo Driver Board
FENWIC
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-03-14 16:28:14
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
A simple snap-fit case for the seeed studio Servo Driver Board for XIAO V1.0.
No screws required — just press-fit.
Added a bottom case that mounts to the SO-101 base on September 13, 2025.
Recommended Print Settings
Material: PETG
Nozzle Diameter: 0.4mm
Layer Height: 0.2mm
Supports:
Not required - servo_driver_case_upper.stl, servo_driver_case_lower_plain.stl
Please print with a brim for better bed adhesion. - servo_driver_case_lower_with_tabs.stl
Infill: 15%
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY