i was looking for a case for my shift lights and gear indicator to run them off the same arduino nano, was a fan of mehmetdmr_60s design but i had no use for the 4 digit 7 segment display so lightly modified the front faceplate to remove the hole for it and flipped the design so it just has the lights and the gear display

Creality

Ender 3

No

No

20

a flaw ive noticed with the original design is that some holes seem to be weirdly sized, such as the nut holes in the back plate being too big for M3 nuts but too small for M4 nuts, unfortunately im new to 3d printing as a whole so i dont have the experience to fix this so i just worked around it but using some 8G self tapping screws to screw the front plate into the back plate also i did have to modify the final print with some nippers as i discovered my leds would not fit in the predefined square holes, your experience may vary