This is a two-part design intended to loosely fit 60 sleeved cards:
- Rigid and robust design
- Additional slot to house an instruction sheet (see pictures)
- Impression for original game box to be cut and glued into if applicable (see pictures)
- Printing tolerances included for fit

Once printed, the fit will be tight, slide the parts together and apart a few times to loosen it up. If fit issues persist, try reviewing the recommended print settings.

Print Settings:
0.2mm layer height
2mm wall thickness
Support on any ledge greater than 80deg 10% infil
I used gyroid infil at 10%
Brim adhesion
Print Lid.stl with the instruction sheet slot facing up (no support needed)
Print Box.stl with the card opening facing upwards (support needed)