A parametric switch holder. Could be used to create a switch tester or lubing station or what ever you might come up with.

Latest source can be found on github: https://github.com/qwelyt/Parametric-switch-holder

---- Update 2, 2019-08-25 ----
Add support for ALPS switches.

---- Update 1, 2019-08-24 ----
Updated the SCAD file with new default values to support Kailh, added legs option, added puzzle option.

Legs: If you want to use less material when printing you can now opt to
use a thinner case but add legs to lift it up from the ground to have
the switches not touch the floor.

Puzzle: Ever wanted to make a MASSIVE switch holder but don't have a
MASSIVE printer? Print it in pieces and lay them in a puzzle! You can
glue them together if you want them to stick like that, or just hook
them in temporary.

Kailh: The Kailh box switches do not have the same side cuts as Cherry
or Gateron. This meant that the default values made it difficult to put
the Kailh switches in the holder. Updated default values now allow for
Kailh, albite still a snugger fit than Cherry or Gateron but I think it
will be problematic to support all equally well.

---- Original ----

Right now it only has support for MX-switches but I'm thinking about adding support for ALPS as well. Just need a model to go off.

If used for a lubing station or switch tester, don't make the thickness less than 9 or the legs of the switch will stick out from underneath.
It you think it's to snug or too loose, enter the danger zone and adapt to your liking. You can select to see a switch to help determine the fit.
The switch model was created by gcb, you can find it here https://www.thingiverse.com/thing:421524