A 65% ISO Keyboard with 4.5 degree angle.

Mount for Pi Pico controller using KMK, https://github.com/KMKfw/kmk_firmware

Print settings:

Print plate at 0.1mm layer height as the vertical dimensions are critical for the keyswitches to clip in correctly
PLA or PETG, using PLA will give a stiffer case
You will need a brim or lily pads to stop the corners lifting
Support on build plate

Hardware required:

M3 x 8mm Socket Cap Head Screws
M3 x 12mm Socket Cap Head Screws
M3 x 6mm Socket Countersunk Screws
M3 Full Nuts
Cherry MX Keyswitches
Keycaps
Raspberry Pi Pico
1N4148 Diodes
8x3mm Rubber Feet