I created this tool when I was working as a PV/Solar Inspector. The tool can be used to combine the different PV strings in a Solar Installation.

When inspecting some PV installations I noticed how much time it took to get the measurement leads on and off the different strings of solar panels so after getting my 3D printer I decided I could make my work a bit more efficient.

I've tested the design, printed in PLA on my Ender 3 V2 and it works like a dream, fits all connectors as long as the leads are no bigger than 6mm2. 

It should clamp the leads in nice and tight.

This is for the side of the leads. For the tester side I have made some cable combs I will share in a different model page.

Material: PLA

Infill 50%