Snap on Bucket Handle
JollyTower
Encuentre similares con IA
Perfil de impresión(0)
Archivo de modelo(0)
0
0
0
Publicado:2026-01-16 23:46:58
0
0
000Descripción
Etiquetas
Fuente del modelo
Comentarios(0)
Made for wire loop large buckets with a cheap handle that breaks off with normal use.
The gap is about 1mm wide but i tried it on a 2mm wire and a 3/16" wire and both worked. It is 76 mm long which is about the same as most bucket handles.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Doesn't Matter
Supports:
No
0.2mm
Infill:
100%
Notes:
Use a brim of at least 4mm to keep build plate adhesion to the end. 100% infill recommended because leaving it hollow allows for more flexing which might let it snap.
Etiquetas
Fuente del modelo
Enlace original: Ver detalles
CC-BY